![]() Depending on your board, some screw holes may not be used. Using the PH2 bit, fasten the motherboard to the inside of the case using the round 6-32 flat screws found in the white box on step G. Inside you'll find many screws with a rounded top.Īlign the metal standoff in the case with the middle screw hole on the motherboard.Īlign your motherboard with the middle standoff in the case - the screw holes of the motherboard should align with those inside the case. In the white NZXT box, find the baggie of 6-32 flat screws. Align the ports on the motherboard with the holes of the rear IO so that they fit together. Place your motherboard into the PC case angled toward the IO shield. Here on this page, you’ll find the IO shield’s meaning, uses, and installation guide, and at the end, I’ll conclude with the necessity of an IO shield on your PC. Don't be afraid to bend the metal to better fit the ports. Step-by-Step Hardware, How To / By Aswarth Narayana The IO shield in a computer has its unique advantage, but it is less prioritized when compared to the other components in a computer. Press firmly on all 4 corners of the IO shield until it “pops” in. Match the orientation of the IO cutouts to your motherboard. If your IO shield was provided separately, put the metallic IO shield into the rectangular opening in the back of the PC, shiny side facing inwards.Ĭaution: Some of the metal edges are sharp. In many cases it may be pre-attached to the motherboard already, though often it is provided as a separate piece. Place it down gently, with the open interior facing upwards.Ī metallic IO shield will be provided with your motherboard. Now is a good time to place the PC on its side. Take note of the “6-32 screw flat” and “kb 5*10 screw” bags, as well as the zip ties and the audio splitter. Not every part will be used, as some were provided as extras. This box contains many screws and tools that will help you during the build. In one of the compartments you will find an included box of parts necessary to continue building your PC. Unscrew the captive screws holding the rear panel in place, located at the back of the case. The panel is fragile glass, so be sure to place the panel down gently in a safe place where it will not be damaged. Holding the glass, gently pull the top of the panel towards you, and then lift the panel upwards and out of the way. Use both hands when handling glass paneling. Bracing the glass with one hand, pull on this tab. On the rear of the PC (where the panel was unscrewed) is a metal pull tab. Turn the screw until it wobbles in place. The thumb screw holding the glass panel is captive, meaning it won't come completely off the tab. Take the H510 out from its packaging, and have the motherboard on standby for the next step. We’ve reached a milestone! The next step of the adventure will be moving your build into your H510 case (marked G).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |